What kind of oil for 1998 honda civic

The 0W is said to be the best oil in the market because it helps to reduce environment hassle on waste oil disposal. Motor oil grade 5W is recommended for all Toyota engines. It has a higher viscosity to properly coat four and six cylinder engines. Toyota recommends changing this oil type every 3, miles.

Synthetic oil usually should be changed every 7, — 10, miles. Do I need to use genuine Toyota motor oil? However, for the best possible performance, genuine Toyota motor oil is recommended because it includes a blend of additives specifically formulated to help your Toyota run smoothly until your next service appointment. By using the recommended type of synthetic oil, an engine will stay cleaner and last longer than if conventional oil is used.

Additionally, synthetic oil does a better job of protecting an engine over a wider range of temperatures than its conventional counterparts. An oil to seal the clearances within your engine and gives you maximum power of your engine. Oil that cools and soothes your engine under extreme conditions of heat. Oil that not only lubricates but also cleans, to give your engine sludge free life. Even if you put together synthetic and conventional blends of these motor oils, they show no harm to your vehicle.

Best Answer Mark helpful. Mark helpful. Your Answer:. Upload Photo Photo optional. Related Questions. Start a new Honda Civic question. Own this car? Share your experience with others. Write a car review. Search Honda Civic Questions. Due to the confined space, it must be removed the rest of the way by hand.

Remove the gasket ring from the inside lip of the old filter. Ensure that it is free of debris and lubricate it with a small amount of clean oil. Place the gasket in the new filter; it should simply lie inside the open end of the filter.

Place the new filter where you removed the old one. There is a short bit of metal pipe in the middle of this area, so make sure that it goes into the center of the filter.

Tighten the filter by turning clockwise as far as you can by hand, then tighten the rest of the way with the filter wrench. Remove the oil filler cap located on the back, right-hand side of the engine block near the "A" in Honda. Place a funnel in the exposed tube and add 5 qts. Remove the funnel and screw the filler cap back on tightly. Pull the engine oil dipstick out. It is in front of the engine block, slightly left of center.

Wipe the oil from the dipstick and insert it back in the tube. Pull it out again and ensure that the oil level is between the two dots drilled into the hole. Replace the dipstick into the tube.